Search

Care Instructions

1. For best results, wait 24 hours before first wash.

2. Always turn inside out when washing.



TIPS

  1. Make sure to set mirror mode in advance of cutting, so the result appears as expected.

  2. Always cover all part of your image with protective film before heat transfer.(Protective film is reusable.)

  3. If a section of the image does not adhere, replace the protective film and re-iron the loose section, using the tip of the iron in a continuous motion with medium pressure for approximately 10 seconds.

  4. Ensure the platform is flat enough and put towel or silicon mat underneath the material when heat transferring.

  5. Make sure to set mirror mode in advance of cutting, so the result appears as expected.

  6. Always cover all part of your image with protective film before heat transfer.(Protective film is reusable.)



Follow instructions of cutting machine and product intended for design application. It is recommended to test iron-on material in an unnoticeable location prior to use. Use caution when operating iron or heat press.

Adult supervision required. Iron-on material is to be used at consumer's own risk; results may vary.